Ride Tech Moto ReviewsSee store reviews

This is my 2nd mount for the neotec II (XS) for the 1st one simply fell off with the camera attached. This new one (with apparently better sticking/ glueing capacities) has only been on the helmet for a bit over a week. have attached the camera to the mount (with helmet upside down) and have left it like that for 5/ 6 hours. So far the mount is still holding strong. Will do this experiment once again before actually taking the camera out on the bike. Only point, so far, for improvement would be ...

The bracket is really well made, the only very minor gripe I have (and it’s very minor) on the shoei gt air 2, and on my cbr 650r the angle of the GoPro is just slightly too low. It would be good to have the ability to just tilt it up ever so slightly more. At the moment it’s pushed hard against the helmet and I can’t see up the road in front of me unless I tilt my head up, which doesn’t feel the natural position. I’m not sure what it’s called but the plastic bracket with 3 lugs on each end coul...

I actually skipped back to the standard display color as the shadow of my Mobile made it impossible to read some info on the display. I was actually hoping to eliminate the bright reflection of the sun making it dangerous to drive and to read any info on the LCD. As the dark color didn't help I went back and sticked a kind of paperlike foil on top of the LCD which enhanced the blending. To enhance your product I recommend to put a number 1 and 2 sticker on the equivalent sides, so that it is cle...

System is much preferable to the competition. I like being able to detach my camera easily. I’m very confident in the mechanism’s ability to hold onto the camera. I did supplement the adhesive to make sure it stayed on. Product fit my helmet pretty well. No complaints there. The base appears to be 3D printed — though it is hardly noticeable when the product is new. I can only really tell because I scuffed a corner of the base and it has damaged a bit. Whatever 3D printer they’re using...

The package arrived after a month using their standard delivery method. I will definitely be using their tracked shipping next time now that I know this is international. As for the product itself, it arrived intact and undamaged and has been attached to my helmet. I wasn't allowed to use it during my training and therefore haven't fully tested it but I would say that it was sturdy enough to support the helmet when I did their "shake test". The only possible improvement i can see is the changin...

The mount look fairly good however I was expecting a plastic mold and not a 3D printed part. Since it was 3D printed it could have used a bit of clean up with sandpaper to smooth out the rough groves. Other than that, it fits well and has super simplified install process. The 3M adhesive has started to peel off with about 500-700 miles but replacements are most likely inexpensive. Long story short, if you have a 3D printer I would look up and see if they have public designs already made however ...